Richmond, IN · Serving East-Central Indiana Call or text anytime
Licensed & Insured — Indiana & Ohio
Mike Spurrier · November 18, 2026

One Switch Runs Half the House: A Richmond Inspection Finding

Certified Home Inspection inspector in front of a home in Richmond, Indiana

We were in Richmond today for a home inspection, and this house had a puzzle in it — the kind you only solve by working through a circuit switch by switch, outlet by outlet. Every photo in this post is from today’s job.

One switch runs the show

Single-pole light switch in a Richmond, Indiana home
Richmond, Indiana
Home inspector testing the switch that controls multiple lights and outlets in a Richmond, Indiana home
Richmond, Indiana

It started with a bedroom light that would not behave. Flip its switch and sometimes nothing happened. The reason took some tracing: the bedroom light is not wired the way two-location lighting normally is. A switch on the bedroom’s north wall has to be on before the bedroom light’s own switch has any power at all. Both switches are standard single-pole on/off switches — not a three-way pair — so the light only operates when both are on, and it cannot be controlled from either location on its own.

That would be finding enough. It was not the whole circuit.

The closet, the upstairs, and a wall of outlets

Finished second-floor room in a Richmond, Indiana home
Richmond, Indiana

The same north-wall switch also controls the light in the finished second-floor room above. And the bedroom’s closet light is on the same chain — with the north-wall switch off, the closet light cannot be turned on either.

Outlet tester showing no power at a switch-controlled receptacle in a Richmond, Indiana home
Richmond, Indiana

Then the receptacles. The outlets along the west wall of the finished second-floor room are wired through the switch as well — turn the switch off and that whole wall of outlets goes dead. The receptacles on the opposite wall have constant power, the way receptacles should. Picture the first night in this house: lamps and a phone charger plugged into the west wall, the light switched off at bedtime, and half the room’s outlets dead for no reason the new owner can see.

Here is the finding the way it goes into the report:

“The bedroom and finished second-floor lighting, and some receptacles, are wired through a single switch on the bedroom’s north wall. That switch controls the second-floor lights directly and also supplies power to the bedroom light’s switch, the closet light’s switch, and the receptacles along the second-floor room’s west wall. With the north wall switch off, the bedroom and closet lights cannot be turned on, the second-floor lights are out, and the west wall receptacles have no power. The receptacles on the opposite wall of the second-floor room have constant power. The lights and receptacles are not wired for independent control as intended. Recommend evaluation and correction by a licensed electrician.”

This is not a burned-out bulb or a tripped breaker — it is how the circuit was wired. The correction is a job for a licensed electrician, who can separate the circuits so each light is controlled at its own location and the receptacles carry constant power.

The other half of the story

Home inspector in a knee wall attic during a home inspection in Richmond, Indiana
Richmond, Indiana
Open splice box with exposed splices in a knee wall attic in a Richmond, Indiana home
Richmond, Indiana

The knee wall attic held the other half of the story: an open splice box — a junction box with no cover, its splices exposed — on the attic floor beside the insulation. It appears to be the point where these circuits are tied together. Open splices belong inside a covered box, so it goes in the report alongside the switch finding, for the same licensed electrician to correct.

The rest of the walk

Home inspector checking the plumbing under the kitchen sink during a home inspection in Richmond, Indiana
Richmond, Indiana

A finding like this one is why the inspection tests switches and receptacles room by room instead of assuming they work. The rest of today’s inspection followed the same pattern: every sink cabinet opened and checked for leaks and staining, the electrical panel and a sampling of receptacles tested, the furnace and water heater checked, and the exterior, roof, and attic walked and documented. The inspection covers what is visible and accessible at the time; we do not open walls, and we do not guess at what is behind them. What we can test, we test — and what we find goes in the report with photos, in plain language.

How the day ends

Near the end of the inspection, the buyers join us for a wrap-up: everything we found, gone over on site, with every question answered before we leave. The written report follows the same day. If you are buying in Richmond, you can see what an inspection covers on our home inspection page and what it costs on our prices page. With two inspectors on our team, we can typically get your inspection scheduled inside the 7-to-10-day inspection response window in your purchase contract.

Certified Home Inspection LLC has been inspecting homes in Richmond and across East-Central Indiana and West-Central Ohio since 2004.